Nghĩa của từ small section rolling mill bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: cơ khí & công trình
-máy cán hình cỡ nhỏ

Đặt câu có từ "small section rolling mill"

Dưới đây là những mẫu câu có chứa từ "small section rolling mill", trong bộ từ điển Từ điển Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ small section rolling mill, hoặc tham khảo ngữ cảnh sử dụng từ small section rolling mill trong bộ từ điển Từ điển Anh - Việt

1. Byelorussian Steel Works is highly technological rolling production is represented by a modernized light-section mill 320, a wire mill 150 and a medium-section reversing mill 850

2. Specialized processing rolling mill accessories.

3. I guess this also applies to rolling mill.

4. A heavy steel rolling mill is being built.

5. Astatizer Poster will be rolling by the mill

6. Roll for intermediate and finishing stands of bar, wire-rod mills and section mills; stretch reducing rings for seamless-tube rolling mill.

7. Double stand reversing cold strip mill is an important rolling mill type because of its merits.

8. Oct 200 The No.1 Cold Rolling Mill started construction.

9. The structure of rough rolling simulation system was established based on the Baosteel 2050 rolling mill.

10. Rolling mill equipment is a major component of the mainframe out.

11. Four row cylinder roller bearings are most widely used in rolling mill.

12. This paper analyzes the characteristics of hydraulic loop system of rolling mill.

13. In addition, the rolling mill was valued by PROFCEN in Częstochowa at PLN [...] million

14. Method and device for pre-stressing tapered roller bearings of a rolling mill roller

15. Armco Inc., American corporation first incorporated, as the American Rolling Mill Company, on Dec

16. The dynamic simulation model of hydraulic system for width control of rough rolling was established based on the Bao Steel 2050 rolling mill.

17. The rigidity of rolling mill is imporatem factor for control precision accuracy of plate thickness.

18. The cold rolled coils are delivered from cold rolling mill into hot dip galvanizing workshop.

19. TSI Rolling Stock HS: Actual no requirement specified in section

20. A simple adaptive control system was designed for constant tension of double stand revere rolling mill.

21. The joint properties of a metal strip being rolled in a hot strip rolling mill, especially a steel strip, are adjusted in the cooling stretch of said mill by cooling.

22. One method of rolling Billets, which are usually 75 to 125 millimetres square, is to use a three-high mill …

23. Build center tubes for the Autowinder rolling section using plastic sleeves and a heat gun

24. Finally, the torsion vibration nature frequency and torque amplitude factor of a rolling mill are calculated by using finite element method.

25. It is a general issue that the meshing force between the gears in the rolling mill herringbone gear stand is not sufficient.