Nghĩa của từ maximum operating pressure bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: cơ khí & công trình
-áp lực làm việc lớn nhất
@Lĩnh vực: xây dựng
-áp lực vận hành lớn nhất
Đặt câu có từ "maximum operating pressure"
1. The targeted specifications, including mass, volume, maximum expected operating pressure, propellant expulsion efficiency and propellant storage life, are determined.
2. The net effect on the pressure distribution is maximum pressure amplitude at points of maximum compression and minimum pressure at points of maximum rarefaction.
3. 1.3.2. Maximum allowable back pressure:
4. Maximum allowable back-pressure: ... kPa
5. - the maximum working pressure allowed.
6. The plant is operating at maximum capacity .
7. Maximum admissible operating temperature of conductor is 70 ℃.
8. More pressure as tip size increases (15 PSI maximum Acetylene pressure)
9. Nominal working pressure(s) and if downstream of the first pressure regulator, maximum allowable working pressure(s) # a
10. Nominal working pressure(s) and if downstream of the first pressure regulator, maximum allowable working pressure(s): ... MPa
11. Method for operating an absolute pressure or relative pressure sensor with a capacitive transducer
12. Maximum allowable exhaust back pressure of the REC: ... kPa
13. (i) the highest effective pressure allowed in the shell during filling ('maximum filling pressure allowed`);
14. Maximum pressure ranged 3243.5 to 3251.2 mbar absolute during sterilization.
15. The A-weighted maximum noise pressure level shall be reported
16. - a leakproofness test at the maximum allowable working pressure; and
17. The A-weighted maximum noise pressure level shall be reported.
18. (ii) the highest effective pressure allowed in the shell during discharge ('maximum discharge pressure allowed`); and
19. b) The maximum vapour pressure (absolute pressure) at # °C of the substance does not exceed # kPa ( # bar
20. Maximum Allowable Working Pressure (MAWP) = 6 atm (gauge) = 7 atm (absolute)
21. During this test the equipment under test (EUT) will be connected to a source of aerostatic pressure (of #,# times the maximum pressure and in the case of a Class # component, #,# times the maximum classification pressure
22. The maximum expected Circulating pressure is the total frictional pressure loss and pressure drop at the bit at the total hole depth
23. To compare a pressure expressed in gauge pressure with a pressure expressed in absolute pressure the atmospheric pressure should be deducted from the absolute pressure which is missing in the definition of maximum working pressure.
24. b)(i) Below the headings "Maximum allowable working pressure (MAWP)" and "Design pressure" amend (b)(i) to read
25. The momentary pressure surge referred to in 2.11.2 must be kept to 10 % of the maximum allowable pressure.