Nghĩa của từ allowable (unit) stress bằng Tiếng Việt

@Chuyên ngành kỹ thuật
-ứng suất an toàn
-ứng suất cho phép

Đặt câu có từ "allowable unit stress"

Dưới đây là những mẫu câu có chứa từ "allowable unit stress", trong bộ từ điển Từ điển Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ allowable unit stress, hoặc tham khảo ngữ cảnh sử dụng từ allowable unit stress trong bộ từ điển Từ điển Anh - Việt

1. 2005) for Allowable Stress Design and limit state design (LRFD)

2. For both types of beams the allowable stress is the same.

3. Selection basis and method on allowable contact stress of rolling ball-socket nozzle were described. Based on empirical formula and test data, several factors affecting allowable stress were analyzed.

4. Steel that was considerably Brittler and had a lower allowable working stress

5. Allowable synonyms, Allowable pronunciation, Allowable translation, English dictionary definition of Allowable

6. (b) without exceeding the allowable unit stresses for the material used in the fixed support.

7. Allowable stress design is based on the following design principles and assumptions: Within the range of Allowable stresses, masonry elements satisfy applicable conditions of equilibrium and compatibility of strains

8. Improved stress monitoring equipment and accurate loading computers have helped ensure that stresses are kept within allowable limits.

9. The Designer must read the Allowable load from the applicable table and adjust the Allowable load for all applicable design parameters for the anchor, such as spacing, edge distance, in-service temperature or Allowable-stress increase for short-term loads.

10. Start studying Allowable and Non-Allowable Assets

11. Special attention has been paid to factors of safety and allowable stress, areas where a certain amount of controversy exists.

12. Allowable stresses

13. In the design method the beam flexural stiffness is designed to give an adequate distribution of the interface stress so that the maximum stress in the wall does not exceed allowable limits.

14. Allowable errors

15. Allowable shearing stresses for shear walls should be taken as the sum of the Allowable shear stress given in Table 11.5 or 11.6 and one-fifth the average compressive stress produced by dead load at the level being analyzed, but not more than the maximum values listed in these tables.

16. In the design method the beam flexural stiffness is calculated to give an adequate distribution of the interface stress so that the maximum stress in the wall does not exceed allowable limits.

17. Allowable definition, that may be allowed; legitimate; permissible: an Allowable tax deduction

18. TOTAL ALLOWABLE CATCHES

19. Allowable definition is - permissible

20. Total Allowable Catches (TACs)

21. Total Allowable Catch (TAC)

22. Rebates and Allowable Discounts - Indicate other rebates or allowable discounts received from the exporter.

23. Maximum allowable hydrogen leakage.

24. Allowable: that may be permitted.

25. - essential maximum/minimum allowable limits;