Nghĩa của từ allowable flexural stress bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-ứng suất uốn cho phép

Đặt câu có từ "allowable flexural stress"

1. Bending tests reveal the elastic modulus of Bending, flexural stress, and flexural strain of a material

2. In the design method the beam flexural stiffness is designed to give an adequate distribution of the interface stress so that the maximum stress in the wall does not exceed allowable limits.

3. In the design method the beam flexural stiffness is calculated to give an adequate distribution of the interface stress so that the maximum stress in the wall does not exceed allowable limits.

4. Key words: thermal pressure, water tank, ice cap, mathematical model, design charts, hoop stress, flexural stress.

5. 2005) for Allowable Stress Design and limit state design (LRFD)

6. For both types of beams the allowable stress is the same.

7. During flexural toppling, the major principal stress is oriented predominantly parallel with the slope surface.

8. Selection basis and method on allowable contact stress of rolling ball-socket nozzle were described. Based on empirical formula and test data, several factors affecting allowable stress were analyzed.

9. Steel that was considerably Brittler and had a lower allowable working stress

10. Allowable synonyms, Allowable pronunciation, Allowable translation, English dictionary definition of Allowable

11. Allowable stress design is based on the following design principles and assumptions: Within the range of Allowable stresses, masonry elements satisfy applicable conditions of equilibrium and compatibility of strains

12. Improved stress monitoring equipment and accurate loading computers have helped ensure that stresses are kept within allowable limits.

13. Vertical casting reduced not only flexural strength but also the capability of the fibres in resisting stress in the post-cracking stages.

14. Jan. 2010 The new Elaflon PTFE multipurpose hoses from ContiTech combine flexural fatigue strength and resistance to stress cracking with high temperature stability.

15. The Designer must read the Allowable load from the applicable table and adjust the Allowable load for all applicable design parameters for the anchor, such as spacing, edge distance, in-service temperature or Allowable-stress increase for short-term loads.

16. Start studying Allowable and Non-Allowable Assets

17. It was found that machine stiffness has no significant effect on the compressive strength, the flexural strength, or the critical stress intensity factor.

18. In order to estimate the flexural behaviour of reinforced concrete members, the stress–strain behaviour of the constituent materials must be well established.

19. Special attention has been paid to factors of safety and allowable stress, areas where a certain amount of controversy exists.

20. The invention relates to a piezo flexural transducer unit which contains at least two flexural transducers (4, 5).

21. Allowable stresses

22. The results obtained show that this new method of testing allows the acceleration of damage when the rate of flexural stress reaches about 60% of the rupture load.

23. Allowable errors

24. Allowable shearing stresses for shear walls should be taken as the sum of the Allowable shear stress given in Table 11.5 or 11.6 and one-fifth the average compressive stress produced by dead load at the level being analyzed, but not more than the maximum values listed in these tables.

25. Allowable definition, that may be allowed; legitimate; permissible: an Allowable tax deduction