Nghĩa của từ single-phase flow bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: hóa học & vật liệu
-dòng một pha
Đặt câu có từ "single-phase flow"
1. Single Phase and Three Phase Autotransformers
2. Multiple air flow paths using single axial fan
3. The Binodal curve is the boundary between the 2-phase condition and the single-phase condition
4. Welding equipment powered by single-phase and three-phase power sources with alternating current (AC) output
5. The focus in this phase was on order flow and gross revenue .
6. Methods:Tube flow phantoms which simulating the cerebral blood flow were established. Flow signal intensity of the steady flow in tubes was measured by MR phase-contrast cine technique.
7. Cooling an electronic device in an aircraft by case-by-case single-phase or two-phase cooling
8. Single-phase AC motors of an ouput > 750 W
9. Compression in phase on 2 bogies and a single rail.
10. Single-phase AC motors of an output > 750 W
11. AC motors, single-phase, of an output > 37,5 W
12. In the first phase of Coining, adjacent asperities cooperate to cause flow and
13. Flow velocity measurements were carried out using the magneto-acoustic phase conjugation technique.
14. Expected supervision/accreditation status flow for a single CSP service
15. Boiling and two-phase flow phenomena of refrigerant-based nanofluids: fundamentals, applications and challenges
16. It can be shown that the theories on gas/solid two-phase flow developed for air and mist drilling and theories on liquid/gas two-phase flow developed for oil production through tubing are inaccurate when applied to Aerated mud flow in an annular
17. Embedded device for measuring component and composition of multi-phase flow fluid flowing in pipe
18. Three-phase ac-dc converte with high-frequency insulation by single stage
19. Homogeneous means that the components of the mixture form a single phase.
Sự đồng nhất có nghĩa là các thành phần của hỗn hợp tạo thành một pha duy nhất.
20. The main parameters of gas-liquid two-phase flow, such as flow patterns, pressure drop and liquid hold-up, are investigated in this paper.
21. A measurement technique which does not disturb the flow characteristics is described for determining the void fraction of an adiabatic two-phase flow system.
22. Available in three-phase and single-phase models, our Autotransformers are typically used in low-voltage situations, 600 volts or less.
23. The following distribution systems are allowed for direct and single-phase alternating current:
24. The following distribution systems are allowed for direct and single-phase alternating current
25. Contactors are typically built for and used in 3-phase applications where a relay is more commonly used in single phase applications