Nghĩa của từ plastic deformation energy bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: vật lý
-năng lượng biến dạng dẻo
Đặt câu có từ "plastic deformation energy"
1. Under excessive tensile strain, the tubes will undergo plastic deformation, which means the deformation is permanent.
2. Accumulative roll bonding (ARB) is a severe plastic deformation (SPD) process
3. In the 1930s, his research was supplemented with works on the theory of plastic deformation.
4. Ductility is a measure of the degree of plastic deformation that has been sustained at fracture.
5. Absorbed energy for the body section, derived from the measured load-deformation curve
6. 22 Powder metallurgical material is compressible in plastic deformation . Its plasticity method needs to be further researched.
7. An approximate analysis using a bilinear representation of the stress-strain behaviour has been made for the energy of plastic deformation at the tip of a crack growing under sinusoidal loading of constant amplitude.
8. Fine Blanking makes use of additional supporting tools (pads) and impingement technology to minimize plastic deformation during the shearing
9. Sheet metal Bending is the plastic deformation of the work over an axis, creating a change in the part's geometry
10. The fibrils, which have been torn away from the fibre bundles, show signs of considerable plastic deformation especially in Alkalised …
11. Finally, researchers studied amorphous carbon, a coating material with superior wear resistance, to understand plastic deformation at asperity–asperity junctions.
12. In physics and materials science, plAsticity, also known as plastic deformation, is the ability of a solid material to undergo permanent deformation, a non-reversible change of shape in response to applied forces
13. Accumulative roll bonding is a relatively new severe plastic deformation (SPD) process, which was originally introduced and developed by Saito et al
14. Additionally, the grains of sand are bonded together with the elastic or flexible urethane acrylate resin, likewise reducing plastic deformation and cracking.
15. When abrasive grains impacted on the work piece surface, the top layer atomics are removed, plastic deformation appears at the same time.
16. Burnishing may refer to: Burnishing (metal), plastic deformation of a surface due to sliding contact with another object Burnishing (pottery), pottery polishing treatment
17. Brittleness is defined as the tendency of solid material to undergo negligible plastic deformation before fracture when it is subjected to external tensile loading
18. The static analysis of the structure is used in order to fix the critical deformation state and hence the critical strain energy.
19. Modelling of deformation behaviour.
20. According to Hertz contact theory, this paper discussed the elastic deformation in the ball screw systems and elastic potential energy caused by it.
21. On base of analysis to simulation result, it was point out the main cause making dissimilar metal"s bonding so difficult was metal"s inharmonic plastic deformation.
22. On the nanoscale the primary plastic deformation in simple face centered cubic metals is reversible, as long as there is no material transport in form of cross-glide.
Ở cấp độ nano các biến dạng dẻo chính trong kim loại mạng lập phương tâm diện (fcc) là có thể đảo ngược, chừng nào không có sự vận chuyển vật liệu dưới dạng trượt ngang.
23. There is a tendency to underestimate the amount of plastic deformation of the capsule and alternative injuries, such as avulsion of the capsule from the humeral head (HAGL lesion).
24. In many problems of plastic deformation, when the prescribed loads or displacement do not increase in proportion but vary in a complex manner, for instance alternating between prescribed limits, more general work-hardening models are needed in order to describe the plastic behavior.
25. Other applications of Crustal deformation include studying hydrologic changes such as draughts and groundwater extraction, and volcanic deformation.