Nghĩa của từ pillar rolling mill bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-máy cán kiểu cột
Đặt câu có từ "pillar rolling mill"
1. Specialized processing rolling mill accessories.
2. I guess this also applies to rolling mill.
3. A heavy steel rolling mill is being built.
4. Astatizer Poster will be rolling by the mill
5. Double stand reversing cold strip mill is an important rolling mill type because of its merits.
6. Oct 200 The No.1 Cold Rolling Mill started construction.
7. The structure of rough rolling simulation system was established based on the Baosteel 2050 rolling mill.
8. Rolling mill equipment is a major component of the mainframe out.
9. Four row cylinder roller bearings are most widely used in rolling mill.
10. This paper analyzes the characteristics of hydraulic loop system of rolling mill.
11. Byelorussian Steel Works is highly technological rolling production is represented by a modernized light-section mill 320, a wire mill 150 and a medium-section reversing mill 850
12. In addition, the rolling mill was valued by PROFCEN in Częstochowa at PLN [...] million
13. Method and device for pre-stressing tapered roller bearings of a rolling mill roller
14. Armco Inc., American corporation first incorporated, as the American Rolling Mill Company, on Dec
15. The dynamic simulation model of hydraulic system for width control of rough rolling was established based on the Bao Steel 2050 rolling mill.
16. The rigidity of rolling mill is imporatem factor for control precision accuracy of plate thickness.
17. The cold rolled coils are delivered from cold rolling mill into hot dip galvanizing workshop.
18. A simple adaptive control system was designed for constant tension of double stand revere rolling mill.
19. The joint properties of a metal strip being rolled in a hot strip rolling mill, especially a steel strip, are adjusted in the cooling stretch of said mill by cooling.
20. One method of rolling Billets, which are usually 75 to 125 millimetres square, is to use a three-high mill …
21. Finally, the torsion vibration nature frequency and torque amplitude factor of a rolling mill are calculated by using finite element method.
22. It is a general issue that the meshing force between the gears in the rolling mill herringbone gear stand is not sufficient.
23. It was approved by the Agma membership in February 1989 and supersedes Agma 323.01, Helical and Herringbone Gearing for Rolling Mill Service .
24. Roll for intermediate and finishing stands of bar, wire-rod mills and section mills; stretch reducing rings for seamless-tube rolling mill.
25. Burrers Mill (historical) Burrers Mill (historical) (aka Bailey Mill) Locale