Nghĩa của từ peak - to - mean ratio (pmr) bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: điện tử & viễn thông
-Tỷ số đỉnh/Trung bình

Đặt câu có từ "peak - to - mean ratio pmr"

Dưới đây là những mẫu câu có chứa từ "peak - to - mean ratio pmr", trong bộ từ điển Từ điển Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ peak - to - mean ratio pmr, hoặc tham khảo ngữ cảnh sử dụng từ peak - to - mean ratio pmr trong bộ từ điển Từ điển Anh - Việt

1. The power to mass ratio index (PMR) is used for the calculation of acceleration.

2. || The power to mass ratio index (PMR) is used for the calculation of acceleration.

3. Mean peak serum concentrations averaged 12.8 mg/l with mean peak sputum concentrations of 1.8 mg/l.

4. The minimum volumetric air to water ratio at peak water flow should be 25:1.

5. This thesis mainly discusses the multi-carrier phase code (MCPC) pulses signal, and the design of pulses trains with low peak-mean envelop power ratio (PMEPR).

6. CFVR was registered as the ratio of average peak velocity during hyperemia (hAPV) to at baseline (bAPV).

7. The modification factor is a sliding mean differential between the target ratio and an actual ratio [(E¿b?

8. That year, 1960, saw a peak of 38,382 active Kingdom proclaimers, giving a ratio of one Witness to every 465 persons in Canada.

9. The ratio between the integrated peak areas for each subunit was determined and corrected for the molecular mass of each subunit.

10. The structures have been confirmed on the basis of IR, PMR and analytical results.

11. 8. microprocessors to calculate the cardinal points (beginning of peak, end of peak and top of peak);

12. Peak power = (peak potential in volts) × (peak beam current in amperes).

13. ‧Peak power‧ = (peak potential in volts) × (peak beam current in amperes).

14. Peak power» = (peak potential in volts) × (peak beam current in amperes).

15. It utilizes spectral envelope estimation to obtain envelope and peak signal and calculates signal-to-noise ratio of speech harmonics in iterate form under least square estimate criterion.

16. “Peak power” = (peak potential in volts) × (peak beam current in amperes).

17. 'Peak power' = (peak potential in volts) x (peak beam current in amperes).

18. ‘Peak power’ = (peak potential in volts) x (peak beam current in amperes).

19. ‘Peak power’ = (peak potential in volts) × (peak beam current in amperes).

20. "Peak power" = (peak potential in volts) × (peak beam current in amperes).

21. Equipment specially designed for the interception of analogue Private Mobile Radio (PMR), IEEE 802.11 WLAN;

22. 'Peak power' = (peak potential in volts) × (peak beam current in amperes).

23. [Peak power = (peak potential in volts) x (peak beam current in amperes).]

24. Peak power = (peak potential in volts) x (peak beam current in amperes).

25. The ratio can go up to infinite, which transforms our plug into a limiter, and an Opto model has been added to the old Peak and RMS for our pleasure.