Nghĩa của từ load combination factor bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-hệ số tổ hợp tải trọng
@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-hệ số tổ hợp tải trọng

Đặt câu có từ "load combination factor"

Dưới đây là những mẫu câu có chứa từ "load combination factor", trong bộ từ điển Từ điển Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ load combination factor, hoặc tham khảo ngữ cảnh sử dụng từ load combination factor trong bộ từ điển Từ điển Anh - Việt

1. The friction factor has a little effect on bucking critical load.

2. Key words: load distribution factor, ultimate limit state, load redistribution, nonlinear behaviour, slab-on-girder bridge, OHBD truck.

3. Table 12‐1 Interpretation of the Buckling Load Factor (BLF) illustrates the

4. Serum is an essential factor for the self-renewal of embryonic stem cells in combination with the cytokine leukemia inhibitory factor.

Huyết thanh là một yếu tố cần thiết cho quá trình tự phục hồi của tế bào thân phôi thai kết hợp với các yếu tố ức chế bệnh bạch cầu cytokine.

5. Another factor influencing advisor load, advising approach dictates the amount of attention devoted to each Advisee

6. Depending on driving circumstances (load factor, acceleration) the car automatically switches to the most efficient mode.

7. Combination of EGTA-insensitive (synthetic) skeletal muscle actomyosin with the extracted factor restores the EGTA-sensitivity.

8. Key words : bearing capacity, deformation, batter pile, inclination factor, inclined load, layered soil, model test, sand, clay.

9. The Buckling load factor (BLF) is an indicator of the factor of safety against Buckling or the ratio of the Buckling loads to the currently applied loads

10. It is suggested that seismic requirements should be considered as accidental actions with a load factor αQ = 1.0.

11. The load combinations in ASCE Standard 7 for load and resistance factor design (LRFD) and for allowable stress design (ASD) differ in their treatment of Counteracting loads, where the permanent gravity load (dead load) stabilizes the structural system against the effect of uplift or lateral loads.

12. A Confirmatory factor analysis assumes that you enter the factor analysis with a firm idea about the number of factors you will encounter, and about which variables will most likely load onto each

13. In the both cases exact values of the stress intensity factor for arbitrary loading (arbitrary load amplitude) of the crack are given.

14. Engine output torque is adjusted as required by controlling some combination of ignition timing, intake air flow, fuel injection, and accessory load.

15. The determinative factors are industrial factor, comparative factor, technological factor and institutional factor.

16. the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load

17. Small Dragon Boat Festival holidays, Shantou Airport, 97 flights, with more than 7300 passenger transport passengers, average load factor flights for around 60%.

18. the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load);

19. Compressibility Factor / Z Factor

20. Accelerated durability tests can be applied whereby the service accumulation schedule is performed at a higher load factor than typically experienced in the field.

21. Ist || = || the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load);

22. Ist = the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load),

23. Ist = the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load

24. Ist= the lowest declared value of I at which the meter registers active electrical energy at unity power factor (polyphase meters with balanced load

25. • sediment load – suspended and bed load