Nghĩa của từ line of maximum shearing stress bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-đường ứng xuất kéo lớn nhất
@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-đường ứng xuất kéo lớn nhất

Đặt câu có từ "line of maximum shearing stress"

1. The data are in agreement with the predictions of Bilby, Cottrell and Swinden concerning the static yielding, and indicate that maximum shearing stress rather than shear stress amplitude should be used for best correlation.

2. Based on Shearing Stress Theorem, we know that the shearing stress direction of all the spots on the edge of circular cross-section should be tangent to the circle.

3. Stress marks above the line indicate primary stress, while those below the line show secondary stress.

4. The procedure is based on applying a sinusoidally alternating shearing stress to the substance.

5. Small probes of added shearing stress appeared to cause considerably more accumulated strain-hardening damage to a yield curve than small probes of added tensile stress.

6. The amount of stress must be the maximum permissible stress in the following wall-thickness calculation

7. 14 The results show that the distributing of the maximum principal stress and maximum shear stress are mainly under the control of the landform and fault.

8. Shearing of Wool

9. In DU, unlike in WHA, the thermal softening overcomes the increase in flow stress, permitting adiabatic shearing to occur.

10. (6) DS: above the line of the maximum draught

11. The results show that vertical stress is equal to overburden stress at shallow level. Maximum principal stress is sub horizontal stress in the NE direction.

12. Allowable shearing stresses for shear walls should be taken as the sum of the Allowable shear stress given in Table 11.5 or 11.6 and one-fifth the average compressive stress produced by dead load at the level being analyzed, but not more than the maximum values listed in these tables.

13. Measurement of the maximum adhesion coefficient by measuring stress in a bead of a tyre

14. Stress relaxation when plotted against the logarithm of time results in graphs of linear decreasing stress with straight-line parts.

15. Remember that knots weaken line so avoid undue stress.

16. The tubular bead serves to reinforce the edge such that the edge stress concentration is substantially reduced both in terms of the maximum stress and the actual gradient of stress near the edge.

17. Percentage of arcing at maximum line speed, NQ (%) (minimum duration of arc 5 ms)

18. Optimized design of Rail wheel and axle is finished. Conclusion This result satisfies our national railway standard. The maximum stress is less than the yield stress.

19. The shearing strain is essentially inhomogeneous flow of metal.

20. In addition, a maximum of 3000 contending line items can appear on the page.

21. Line, pole and traps, limited to a maximum two types of gear per vessel.

22. Finally, through an example, the paper get a maximum stress point and stress distribution on a belt tooth and compare them with the solution of fixable plane problem.

23. This paper discusses how to use bottom shearing stress method to determine the resuspension rate and deposition rate, and how to select and calculate the correlative parameter.

24. Mr. Spilchak had indicated that the maximum allowed for stress leave may be only six months.

25. The regulation establishes maximum co-financing rates differentiated in line with the types of actions: