Nghĩa của từ effective internal friction angle bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-góc ma sát trong có ích
Đặt câu có từ "effective internal friction angle"
1. The results show as the moisture increased, the internal friction angle and cohesive strength decrease with shearing strength reduced, which is the prime reason of the slope.
2. The effects of soil friction angle, wall inclination, wall friction angle, amplification of vibration, and horizontal and vertical earthquake acceleration on the active earth pressure have been explored in this study.
3. Internal friction, both independent and dependent of the strain rate, is taken into account.
4. Coating components of an internal combustion engine for reducing friction, wear, and adhesion tendency
5. Selection of properly fitting fixed-angle plate and internal fixation.
6. The analogy between internal friction increment and overstress due to strain-rate sensitivity is clarified.
7. The analogy between internal friction increment and overstress due to strain - rate sensitivity is cla.
8. Measure out the degrees of each internal angle of each triangle.
9. The influence of friction at the bottom and the bottom inclination angle are extensively discussed.
10. Friction gear for a separate accessory group of a belt drive for an internal combustion engine
11. A steering angle limiting value is derived from the reference speed and from the friction correction value and compared with the actual steering angle.
12. Key words: statistics, probability, ultimate bearing capacity, allowable bearing capacity, shallow foundations, friction angle, numerical methods.
13. — Otherwise the power absorbed by the brakes and the internal friction of the bench (PA) must be:
14. The code reproduces shear band inclinations which depend on both the angle of friction and the angle of dilation. Localization occurs at the yield point.
15. The object of investigation is the influence of linearized bottom friction on standing internal Sverdrup waves in channels.
16. The total friction angle (arctanτ/σn) at which sliding occurs provides an estimate of the joint roughness coefficientJRC.
17. Key words : probability, sheet-pile wall, active and passive pressure, friction angle, safety factor, safety margin, reliability index.
18. The friction angle is determined from stresses which are calculated from external loads and the nominal contact area.
19. Recommended effective dose coefficients for internal and external exposures to selected radionuclides Addendum:
20. 6 The cerebellopontine angle segment and internal acoustic meatus segment paralleled the vestibulocochlear nerve.
21. Accordingly, even effective internal controls can provide only reasonable but not absolute assurance.
22. The spring force alters the closing force of the friction clutch (13) in such a way that the torque of the friction clutch (13) is reduced as the steering angle increases.
23. The mass of the actuator is 1.6 g and an angle of > 10° is needed to overcome friction.
24. The Concorde system allows you to angle the support table to allow complete friction free center main string pulling.
25. An analytical solution is developed to determine the active lateral earth pressure distribution on a retaining structure when it consists of a cohesive backfill (internal friction angle f > 0, cohesion c > 0) with an inclined ground surface.