Nghĩa của từ compression-stress analysis bằng Tiếng Việt

@Chuyên ngành kỹ thuật
@Lĩnh vực: xây dựng
-sự tính (toán) chịu né

Đặt câu có từ "compression-stress analysis"

Dưới đây là những mẫu câu có chứa từ "compression-stress analysis", trong bộ từ điển Từ điển Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ compression-stress analysis, hoặc tham khảo ngữ cảnh sử dụng từ compression-stress analysis trong bộ từ điển Từ điển Anh - Việt

1. Stress, strain, bending, compression, shear, torsion, tension, hoop stress, fatigue;

2. If the load is compression on the bar, rather than stretching it, the analysis is the same except that the force F and the stress change sign, and the stress is called Compressive stress

3. Analysis of Birches - Rhythm, Stress and Scansion

4. Results show that stress shielding effect of the trihedral fix trough plate is lower than the trapezoid compression plate and Tianjin compression plate.

5. From the correlation with foreland basins abroad it is concluded that Sichuan basin resulted from Polydirectional compression stress.

6. Key words: analysis, concrete (prestress), flexure, partial prestressing, prestressing, strain, stress, steel.

7. It is important to stress the need for a robust analysis of alternatives.

8. The Column Buckling calculator allows for Buckling analysis of long and intermediate-length columns loaded in compression

9. The classical Westergaard type stress function analysis for in-plane stress crack problems is adapted to classical bending of cracked plates for determination of mode-1 stress intensity factors.

10. Apparatus and equipment for the acquisition, compression, transmission, analysis and restoration of satellite images and aerial photographs

11. Usually such data are so extensive that considerable compression or smoothing is a vital preliminary to analysis.

12. The calculations shall use suitable analysis techniques to establish stress distribution throughout the container.

13. The analysis is developed on the basis of the Airy's stress function in the generalized plane stress and by applying the bipolar coordinates.

14. 7 Usually such data are so extensive that considerable compression or smoothing is a vital preliminary to analysis.

15. Adhesiveness was calculated using the area over the negative stress–strain curve after the ﬁrst compression, which represents the work per unit volume. Cohesiveness was deﬁned as the ratio of the area under the second compression curve to the area under the ﬁrst compression.

16. The model used for Buckling analysis is supported by different supports than set by the user in stress, strain analysis type (EPS).

17. Frame-by-frame IVUS analysis revealed a delayed relaxation after systolic compression, which may extend significantly into diastole.

18. Phospholipid fatty acid analysis showed that the bacteria in the groundwater samples faced starvation stress.

19. In order to study the stress and deflection calculation methods, the stress characteristics of castellated beams were obtained through overall and local stability analysis by ANSYS.

20. This paper presents an analysis on the stress tensor in non-heat conducting nematic liquid crystals.

21. Normally the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis

22. The finite element method was used for analysis of heat stress in chip on board ( COB ).

23. In addition, the stress on the osseous cup cavity was determined in the finite-element analysis.

24. Normally the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis.

25. AstrutTie is a strut-tie model analysis/design software for concrete members with disturbed stress region(s)