Nghĩa của từ MPE (maximum permissible exposure) bằng Tiếng Việt


thời gian chiếu xạ cực đại cho phép

Đặt câu có từ "MPE maximum permissible exposure"

Dưới đây là những mẫu câu có chứa từ "MPE maximum permissible exposure", trong bộ từ điển Từ điển Y Khoa Anh - Việt. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ MPE maximum permissible exposure, hoặc tham khảo ngữ cảnh sử dụng từ MPE maximum permissible exposure trong bộ từ điển Từ điển Y Khoa Anh - Việt

1. Maximum permissible stresses.

2. Trackside maximum permissible air speed

3. absolute value of the maximum permissible error

4. The maximum permissible stresses shall be derived from:

5. Comparison of the stresses with the maximum permissible stresses.

6. Ceiling: The maximum level permissible in a financial transaction

7. Number of axles and maximum permissible gross laden weight

8. Aggregate maximum risk exposure per arrangement

9. Total — Aggregate maximum risk exposure per arrangement

10. the maximum aggregate risk exposure of the contract;

11. However, the maximum permissible absolute error cannot be less than the values given below :

12. Alternatively, the manufacturer’s declared maximum combined load for the track trains may be substituted for the maximum permissible vehicle mass.

13. - the greater of the two values: - absolute value of the maximum permissible error, or

14. - Information on the load capacity, maximum permissible weight, axle configuration and age of vehicles;

15. -the absolute value of the maximum permissible error for the minimum measured quantity (Emin).

16. Alternatively, the manufacturer’s declared maximum combined load for the track undercarriages may be substituted for the maximum permissible vehicle mass.

17. -the absolute value of the maximum permissible error given in Table 3 or Table 4.

18. The maximum permissible loadings shall be permanently marked in a clearly legible manner on cranes.

19. The amount of stress must be the maximum permissible stress in the following wall-thickness calculation

20. MAXIMUM PERMISSIBLE ERRORS FOR THE MACHINES SHALL APPLY TO THE NET LOAD FOR ALL POSSIBLE TARE VALUES .

21. Maximum biomass was accumulated on shores of intermediate and high exposure.

22. The selection of diameters shall be verified by comparing the calculated stresses with the maximum permissible stresses

23. - the absolute value of the maximum permissible error where the results are supplied by two continuous (analogue) indicators.

24. the absolute value of the maximum permissible error where the results are supplied by two continuous (analogue) indicators

25. The contract rate sets the maximum interest rate payable on an exposure.