Nghĩa của từ crosspieces bằng Tiếng Anh

noun
1
a beam or bar fixed or placed across something else.
I clung to a crosspiece between two beams, to catch my breath.

Đặt câu với từ "crosspieces"

Dưới đây là những mẫu câu có chứa từ "crosspieces", trong bộ từ điển Từ điển Tiếng Anh. Chúng ta có thể tham khảo những mẫu câu này để đặt câu trong tình huống cần đặt câu với từ crosspieces, hoặc tham khảo ngữ cảnh sử dụng từ crosspieces trong bộ từ điển Từ điển Tiếng Anh

1. Crosspieces synonyms, Crosspieces pronunciation, Crosspieces translation, English dictionary definition of Crosspieces

2. Looking for Crosspieces? Find out information about Crosspieces

3. Place D and E pieces diagonally between Crosspieces, slightly overlapping the horizontal Crosspieces as shown.

4. What are synonyms for Crosspieces?

5. Notch the Crosspieces Anthony Tieuli

6. Lay the remaining five Crosspieces on top, equidistant from each other and perpendicular to the first two Crosspieces

7. From: Yard Crashers Attach the Crosspieces

8. They are connected with small Crosspieces

9. Cut two 2x4 horizontal Crosspieces to support the top and two 2x8 Crosspieces for the benches

10. They are connected with small Crosspieces

11. Nail to Crosspieces at the joints

12. Synonyms for Crosspieces in Free Thesaurus

13. Nail centerpiece to Crosspieces at center joints

14. For more information contact J Crosspieces, For maps and directions to C & J Crosspieces view the map to the right.

15. What does Crosspieces mean? Plural form of crosspiece

16. Weave the verticals over and under the Crosspieces.

17. Crosspieces are solid hardwood creating a unique appearance

18. Put glue on the ends of the Crosspieces and drive finish nails through the stiles to hold the Crosspieces in place

19. Crosspieces of cardan Front Axle 400AN/420/450

20. Old wooden mast with Crosspieces, backstays,mainsail ,staysail

21. Lay side pieces (C) vertically over Crosspieces as shown, setting them about 3 1/2 inches in from the ends of the Crosspieces

22. The extremities (9) of the Crosspieces are embedded in …

23. Attach the upper three bamboo Crosspieces to the three uprights

24. Cut one corner off each end of the bench Crosspieces

25. Below are samples of the AL-Series Caps & Crosspieces.

26. Holes through the aluminum angle where it rests on the Crosspieces

27. Gateway of a Shinto shrine, with two uprights and two Crosspieces

28. The user would also have four Crosspieces of varying lengths

29. Old wooden mast with Crosspieces and backstays, view from deck

30. The AL-Series caps & Crosspieces are available in aluminum

31. Cut the Crosspieces, angling the ends at 6 degrees off square

32. Cut both lattice panels to fit between Crosspieces, approximately 63 inches long

33. Mark a line in the center of one of the long Crosspieces

34. Apply a bead of glue to one end of two short Crosspieces

35. Vaulted Crosspieces block the remained apertures and give to a window the various form

36. In the lancet Crosspieces located over streloobraznymi windows, the openwork stone ornament (fig

37. Those first two Crosspieces will now serve as horizontal supports for the remaining five

38. C & J Crosspieces is located at the address in Biscoe, North Carolina 27209

39. Step 18: Notch Base for Crosspieces The tabletop is designed to float on the base

40. Clamp together and rout dadoes in the four Crosspieces, using the method in Step 6

41. Rundle, rung, spoke - one of the Crosspieces that form the steps of a ladder

42. Each lattice panel will be sandwiched between 1-by-1s mounted to the posts and Crosspieces.

43. Glue, drill, and screw Crosspieces in place with the offset screw method used on the bench.

44. Drill countersunk pilot holes and screw the Crosspieces to the legs with 1¼-inch screws

45. To keep it from sliding, attach two 2 x 2–inch Crosspieces to the underside of the table.

46. After the pleasantries were observed, the torturer would start hammering the Crosspieces with a heavy, iron-enhanced wheel.

47. Crosspiece (plural Crosspieces) A horizontal or transverse beam or similar member that extends across or perpendicular to something

48. Lyle Signs, Inc offers the purchase of caps, rods & Crosspieces for the AL-Series Bracket and the E450 brackets

49. Extended Product Type: IS2-EB6100; Product ID: EB6100; EAN: 8015646681638; Catalog Description: N.2 MIDDLE UPRIGHT Crosspieces D=600MM

50. Board and batten shutters are made from grouped single boards joined together with battens, which are shorter Crosspieces of wood