1. Controlled trials are accepted as the standard method for testing efficacy.

2. Mr. Allen was also referred to provisions in ASTM standard testing method D 3774.

3. When testing the bolt of airplane engine with ultrasonic testing, a new statistical method was introduced to decide the sensitivity standard.

4. Bootstrapping is a nonparametric method which lets us compute estimated standard errors, confidence intervals and hypothesis testing.

5. Device and method for testing randomness

6. Leakage-testing apparatus for an endoscope, and leakage-testing method using same

7. Method for testing a prestressed concrete conduit

8. Coagulase testing is the standard method for differentiating contagious Staphylococcus aureus strains (Coagulase Positive Staph) from other Staphylococcal strains (Coagulase Negative Staph or …

9. Vibration testing apparatus and method using acoustical waves

10. Method for testing and adjusting an ignition device

11. Pde autonomous accuracy certification testing method and system

12. Testing apparatus for testing air permeability on thickness direction of plastic matrix, and method therefor

13. DNA testing is an almost infallible method of identification.

14. Method for testing redundant analogue outputs and associated device

15. Active ingredient and method for testing an active ingredient

16. Wireless access point apparatus and method for testing throughput

17. Circuit arrangement and method for testing a reset circuit

18. Method and apparatus for testing performance of spring support

19. The most widely accepted standard for on-site wastewater treatment certification testing is the NSF/ANSI Standard 40 test.

20. A method and a system for testing capacitive acoustic transducers

21. Alternator testing method and system using timed application of load

22. Diffusion method was used for antibacterial and antifungal activities testing.

23. where necessary, the testing of the method(s) of analysis.

24. A new improved vital gluten quality testing method was developed.

25. When testing plastic sheeting for impact Brittleness, use Test Method D1790

26. Bist method for testing cut-off frequency of low-pass filters

27. Wireless access point apparatus and method for testing signal reception sensitivity

28. The usual Methods : To calculate pile shaft resistance are static method; in situ - testing; empirical method etc.

29. Standard test panels used as substrates for testing paints, adhesives, coatings and rust inhibitors

30. Then hexachlorobiphenyl was quantitatively analyzed by internal standard method.

31. Fire hazard testing — Part 10-2: Abnormal heat — Ball pressure test method

32. Fire hazard testing - Part 10-2: Abnormal heat - Ball pressure test method

33. Astm d1176 + redline : standard practice for sampling and preparing aqueous solutions of engine coolants or Antirusts for testing purposes - includes standard + redline (pdf)

34. Standard Test Method for pH of Engine Coolants and Antirusts

35. Standard Test Method for pH of Engine Coolants and Antirusts

36. The test results of abrasive grain constitution showed that the standard sands and can assure high testing accuracy is capable to unify the testing result.

37. 28 The method can realize nondestructive testing for fuel injection law without disassemble.

38. Crowdsourced testing is an emergent method of QA testing which leverages a dispersed, temporary workforce to test software applications quickly and effectively

39. Machine for testing materials and method for carrying out accelerated tests on materials

40. American Petroleum Institute (API) gravity is defined pursuant to testing method ASTM D287;

41. The present disclosure relates to a testing circuit and a testing method of the comparators incorporated in a flash A/D converter.

42. Objective To establish a strict method for testing and evaluating the fungicide efficacy.

43. Abrasivenesses (CAI ¼ 0: 3 2 5: 6) were investigated using the CER CHAR Scratch Test and some additional ‘‘standard’’ hardrock testing procedures, such as testing

44. The testing of olfactory threshold can be standardized scientifically and quantitatively by using standard olfactory liquids.

45. This Testing Method describes a laboratory method to assess aerobic and anaerobic transformation of organic chemicals in aquatic sediment systems

46. Compressive strength testing procedures for concrete masonry units and other related products are covered by ASTM C 140, Standard Methods of Sampling and Testing Concrete Masonry Units

47. Circuit and method for testing electrically controllable power switches for activating passenger protection means

48. Apparatus and method for testing promoted photo-degradation using light-emitting plasma light source

49. Block and standard cell packing method for automated design area optimization

50. Finally, the gold-standard method of cellular localization is immunoelectron microscopy.

51. Molecular testing (PCR amplification method) revealed a heterozygous mutation responsible for factor V Leiden.

52. Method and apparatus for testing shock absorbers and/or suspension systems in motor vehicles

53. Dynamic current testing can detect some faults that cannot be detected by voltage based test method and quiescent current test method.

54. Key words: concrete, aggregates, alkali-aggregate reaction, standard and accelerated testing for AAR, fly ash, silica fume.

55. Aflatoxin B1 may be used as an internal standard when testing for Aflatoxin contamination in food products

56. Besides coating, the standard protection method is the use of sacrificial Anodes

57. The ASPE proposes a best practice standard method for the quantity survey.

58. a revised method for the standard annual energy consumption of counter cabinets;

59. Endoscopic therapy of colorectal adenomas and early cancers is a standard method.

60. The American national standard for lasers has six classes, and the method of allocation is different from the European standard.

61. Substrate for electrooptic device, active matrix substrate, and method of testing substrate for electrooptic device

62. This professional Brittleness Testing Equipment is designed and engineered in accordance with international test standards including: ASTM D746 (Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact), ASTM D2137 (Standard Test Methods for Rubber Property – Brittleness Point of Flexible Polymers and Coated Fabrics)

63. Testing the Antistatic properties of shoes for certification involves a test method under laboratory conditions

64. Method(s) of testing for emission of harmonics generated on AC power lines from vehicle

65. The invention also relates to a corresponding testing device (1) for carrying out this method.

66. Because above method is not a rigorous ratiocinative method, but a empirical diagnosis based on partial information, this method has robustness to the limitation of testing accuracy and information.

67. Demo loops make the pre-launch report relevant for testing game play, since the standard crawler doesn't support OpenGL.

68. All gliders and light aircraft have to recover satisfactorily with the standard method.

69. (e) a revised method for the standard annual energy consumption of counter cabinets;

70. Method and system for testing an orientation and/or a quality criterion of multilayer ceramic capacitors

71. This method is a particularly popular in market research and testing new initiatives with users/workers.

72. When determining alkaline phosphatase activity, ISO standard #-# must be applied as reference method

73. End-to-end encryption is a standard security method that many companies use.

74. European Community has set and publicated the standard determination method of Sudan red.

75. The stadia method can be used for measuring distances by standard surveying techniques.

76. Dynamic testing is the most important analytical method to assure the quality of real-time systems.

77. Distributed safety monitoring system provided with a safety loop and method of testing such a system

78. Method of testing for immunity of vehicles to surges conducted along AC and DC power lines

79. Each program was based on Charles Allen's 4-point method of Preparation, Presentation, Application, and Testing.

80. Method(s) of testing for emission of harmonics generated on AC power lines from an ESA