1. Limiting the minimum Corroded wall thickness to that recommended in BS 5500 or ASME VIII, but making an additional allowance for mill tolerance

2. Coating and wall thickness gauges, adhesion testers, glossmeters and reflectometers.

3. Hornady Neck Wall Thickness Gauge …Thickness Gauge is a must-have accessory that complements the Hornady Concentricity Tool

4. Below a thickness limit, such walls wall may warp during peeling.

5. Our Borosilicate glass tubing has a wall thickness of 1mm to 1.2mm

6. The absolute cell wall thickness was clearly less related to wood density.

7. 1(5) Tubes and pipes of a wall-thickness not exceeding 4,5 mm.

8. As oppose to round plaingauge tubes which have a consistent wall thickness throughout its length, Butted tubes have variable wall

9. The amount of stress must be the maximum permissible stress in the following wall-thickness calculation

10. Normally the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis

11. Normally the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis.

12. Coring, locally eliminating material in these sections, is a way to pursue a uniform wall thickness

13. Dial-type thickness gauges and dial-type wall thickness gauges graduated in 0,01 and 0,1 mm, Filters, activated charcoal, Labware current sources, Power units, X-ray devices.

14. The rib thickness of at least one of the ribs having at least one angled side wall, as measured in the direction perpendicular to the side wall, can thereby be different from the thickness of the perpendicular ribs.

15. - the values actually measures for the outside diameter of the steel tube and for the wall thickness,

16. Reversible changes in cell wall water content, elasticity, and osmotic adjustment are all important drought tolerance mechanisms.

17. Coarseness, generally defined as weight per unit length of fiber, depends on physical fiber attributes including fiber diameter, cell wall thickness, and cell wall density

18. the values actually measures for the outside diameter of the steel tube and for the wall thickness

19. - the values actually measured for the outside diameter of the steel tube and for the wall thickness,

20. — the values actually measures for the outside diameter of the steel tube and for the wall thickness,

21. NormallyWhenever possible the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis.

22. the values actually measured for the outside diameter of the steel tube and for the wall thickness,

23. the values actually measured for the outside diameter of the steel tube and for the wall thickness

24. Samples cut from Culms at internodes 6 with dimensions 25 mm x 25 mm x Culms wall thickness

25. * He began to measure the wall, and its thickness was one reed and its height was one reed.

26. Beaker, with spout, manufactured with uniform wall thickness, offers optimum balance between thermal shock resistance and mechanical strength

27. 6.2.3.1.2 NormallyWhenever possible the wall thickness shall be determined by calculation, accompanied, if needed, by experimental stress analysis.

28. And up to a maximum wall thickness of 1/2 in, creating uniform Bevelings in a single pass

29. Alternatively the graded flexibility can be provided by tapering the wall thickness (80, 80a) of the pusher catheter.

30. Circularity tolerance is a form tolerance

31. Low loft Batting is useful for items like wall hangings or lightweight quilts, where you do not want excessive thickness

32. Age-related morphological changes in the cardiovascular system refer to a thickening of the arterial wall as well as a diffuse increase in the wall thickness of the myocardium.

33. Actually, it appears that highly trained athletes develop a left ventricular fair combination of cavity dilatation and increased wall thickness.

34. When diameter tolerance is specified on top of Circularity tolerance, then the Circularity tolerance is always less than the diameter tolerance.

35. This Chromed steel slide provides a bright tone and is comfortably lightweight, featuring medium wall thickness and a medium diameter

36. 5 We all need tolerance, oodles of tolerance.

37. Masonry chimneys shall not be corbeled more than one-half of the chimney 's wall thickness from a wall or foundation, nor shall a chimney be corbeled from a wall or foundation that is less than 12 inches (305 mm) thick unless it projects equally on each side of the wall, except that on the second story of a two- story dwelling, Corbeling of chimneys on the exterior of the enclosing walls may equal the wall thickness.

38. * Drug tolerance

39. Siletzia's actual thickness, and the estimates of that thickness, vary.

40. The Culms in these kinds of bamboos are hollow in the center as a cylinder and the wall thickness is in average 1.5cm

41. Extremism became tolerance.

42. From Violence to Tolerance

43. Crassitude: Coarseness; thickness; denseness

44. For multilayer thickness measurements. This Panametrics-NDT thickness gage measures simultaneously up to 4 layers.

45. The diameter of the bamboo Culm decreases from the bottom to the top, which causes the thickness of the stem wall to decrease (Zakikhani et al

46. A summary is given regarding intraspe-cific variability, cyst size and shape, wall thickness, size and shape of the calcitic wall crystals, paratabulation, and archeopyle morphology based on the knowledge, which has been accumulated during the last two decades.

47. The Agglomerator (plastic film granulator) is a kind of waste thermoplastic thin film, and wall thickness is less than 2 mm of products can be granulated immediately

48. 23 A transition zone of bony thickness exists along the frontal processes of the maxilla from the piriform aperture to the radix along the lateral nasal wall.

49. — Flange height, thickness and angle

50. Flange height, thickness and angle

51. I have low alcohol tolerance.

52. The necessary wall thickness of the manifolding arrangement for the carriage of UN No 1001 acetylene, dissolved shall be calculated according to an approved code of practice.

53. The tolerance to the impact velocity is ± 2 % and the tolerance to the impact direction is ± 2°.

54. The effective thickness is given by: where, "T" is the physical thickness, and "" is the relative permittivity.

55. The indicators are about the ‘Abiotical’ factors such as climate, soil, salt tolerance and heavy metal tolerance

56. Resource allocation guided by risk tolerance.

57. Tolerance is one of his strengths.

58. We have zero-tolerance to terrorism.

59. Tolerance to alcohol decreases with age.

60. Tolerance is a sign of breeding.

61. Change Cursor Thickness in Windows 10

62. Height : 36″ ( Bollards are available in custom lengths) Pipe Diameter : 4″ Outside Diameter : 4.5″ Wall Thickness :.237″ -Schedule 40 Security Level : Low Weight : 44 lbs Cap style : Dome $ 478.00

63. It explains the basic mechanisms of Chimerism-based tolerance and provides an update on ongoing clinical tolerance trials

64. Wall of Mardu / Amorite Wall / Western Wall

65. Acoustic treatment panel having scalable thickness

66. Then roll dough to wafer thickness.

67. Languedoc was a land of tolerance.

68. 'Optical thickness' is the mathematical product of the index of refraction and the physical thickness of the coating.

69. ‧Optical thickness‧ is the mathematical product of the index of refraction and the physical thickness of the coating.

70. The Aerosol SEAM Thickness Gauge provides objective and repeatable Double Seam Thickness measurements; required for reliable trend analysis.

71. Type of Contaminant Test Test Method Used Medicinal Substance Tolerance Limits Acceptable NHPD’s Tolerance Limits Chemical Contaminants Arsenic

72. Low thickness sound absorptive multilayer composite

73. Drive blades are about equal thickness.

74. Creaminess definition: the property of having the thickness of heavy cream synonyms: thickness, soupiness antonyms: thinness, thick, thin

75. Common Buckthorn has a broad environmental tolerance

76. Zero tolerance policy applies to all citizens.

77. He had a high tolerance for opiates.

78. There should be zero tolerance towards terrorism.

79. Tolerance is classified into central tolerance or peripheral tolerance depending on where the state is originally induced—in the thymus and bone marrow (central) or in other tissues and lymph nodes (peripheral).

80. Aragonite aids concentration and brings tolerance and …