1. Apparatus for moisture absorption

2. — Mats of low moisture-absorption capacity

3. Shock absorption test

4. Common types are dielectric moisture meter, infra - red absorption type moisture meter, etc.

5. — Thin sheets (voiles) of low moisture-absorption capacity

6. Photovoltaic modules comprising plasticized films having a low moisture absorption

7. The moisture resistance additive can impart resistance to moisture absorption and thickness swelling to composite panels prepared therewith.

8. Banjo products are stress cracking resistant and have low moisture absorption

9. (2) An absorption or adsorption device for removing moisture from air.

10. * - SUPERFINE GLASS FIBRE OF LOW MOISTURE ABSORPTION CAPACITY*0 % *AIRBUS , F 28*

11. — Other boards and similar non-woven products of low moisture-absorption capacity

12. * - SUPERFINE GLASS FIBRE OF LOW MOISTURE ABSORPTION CAPACITY * 0 % * AIRBUS , F 28

13. Protective helmets - Test methods — Part 2: Shock absorption

14. * - SUPERFINE GLASS FIBRE OF LOW MOISTURE ABSORPTION CAPACITY*0 % *AIRBUS , CONCORDE , F 28*

15. Protective helmets - Test methods - Part 2: Shock absorption

16. Protective helmets — Test methods — Part 2: Shock absorption

17. Regulation No. 58 specifies neither a uniform load test nor an energy absorption test.

18. information or test data indicate dermal absorption is comparable or higher than oral absorption, or

19. * - SUPERFINE GLASS FIBRE OF LOW MOISTURE ABSORPTION CAPACITY* - *0 % *AIRBUS , CONCORDE , MERCURE , F 28*

20. * - SUPERFINE GLASS FIBRE OF LOW MOISTURE ABSORPTION CAPACITY * - * 0 % * AIRBUS , CONCORDE , MERCURE , F 28

21. Description: this product is white or yellow gauze-like; odorless, tasteless, with moisture absorption.

22. laboratory test -- was one -- and the other was called " the fluorescent treponemal antibody absorption test. "

23. Energy absorption test on the rear part of the seats

24. A food having an oil absorption and moisture transmission retarding, clear, crunchy coating is provided.

25. — Boards and similar non-woven products of low moisture-absorption capacity, covered with paper or metal

26. (iii) Energy absorption test on the rear part of the seats

27. The results of the T3-absorption-test vary meanly by 8.81%.

28. Thanks to ISOMALT’s low moisture absorption, hard-boiled candies do not stick together or experience cold flow.

29. In this manner, the moisture absorption rate, residence time, and chamber size may also be optimized as desired.

30. The carton guards against breakage and odor absorption and helps to prevent moisture loss which lowers egg quality.

31. [Problem] To provide a package that exhibits good moldability, as well as moisture absorption and gas adsorption properties.

32. Energy absorption test of the rear part of the seat-back: yes/no2

33. A process for improving moisture analyzers (Fig 1) or hygrometers that use optical absorption techniques to measure water vapor.

34. Thickness swelling, water absorption and equilibrium moisture content of heartwood boards were always lower than those of sapwood boards.

35. -Gaps larger than 60 mm are allowed if they pass the energy absorption test.

36. TEST FOR ENERGY ABSORPTION CAPACITY IN THE EVENT OF IMPACT AGAINST THE STEERING CONTROL

37. A closed test strip vial is designed to create a seal to keep out air and moisture.

38. There must be no absorption material between the receiving antenna and the vehicle under test.

39. There must be no absorption material between the transmitting antenna and the vehicle under test.

40. The Bibs system provides low moisture absorption and complete coverage against humid air currents to increase the durability of the building.

41. The locations in the test area from where the cores for absorption measurement have been taken;

42. the locations in the test area from where the cores for absorption measurement have been taken;

43. The absorption and adsorption of dichloromethane to soils is highly dependent on soil type, moisture level, and temperature (Koo et al., 1990).

44. The locations in the test area from where the cores for absorption measurement have been taken.

45. Measuring device and method for analysing a test gas by means of an infrared absorption spectroscopy

46. Type of dehumidifier - adsorption, single-adsorption, full-flow, with integral primary preparation. For moisture absorption from air is provided secondary compressed air draining.

47. DampRid Hanging Moisture Absorber Bag eliminates excess moisture DampRid Hanging Moisture Absorber Bag eliminates excess moisture that causes dampness and musty odors

48. This paper describes a test rig to measure the uni-directional water absorption of mortar and concrete.

49. (iv) the locations in the test area from where the cores for absorption measurement have been taken;

50. The smoke values of the test cycle shall be measured in the light absorption coefficient readout mode

51. Through the absorption test it is possible differentiate between the secretions of a secretor or non-secretor.

52. After absorption, the test molecules emit fluorescence of a distinct fluorescent spectrum for each of the conjugates.

53. The smoke values of the test cycle shall be measured in the light absorption coefficient readout mode.

54. Provided is a capacitance detection circuit for using a simple configuration to prevent a decline in insulation resistance from degradation caused by moisture absorption.

55. The resulting pressure treated dietary fiber exhibits reduced calories, higher insoluble fiber content, reduced moisture absorption properties, and greater uniformity from batch to batch.

56. methods for quantification and identification of the test substance and major transformation products in soil and absorption materials;

57. Electric and optical fibre cables - Test methods for non-metallic materials - Part 402: Miscellaneous tests - Water absorption tests

58. For the measurements of energy absorption a three-point bend test on a notched beam has been proposed.

59. Procedures for the preparation of DNP-amine test substances, their absorption spectra and their extinction coefficients are given.

60. methods for quantification and identification of the test substance and major transformation products in soil and absorption materials

61. Electric and optical fibre cables — Test methods for non-metallic materials — Part 402: Miscellaneous tests — Water absorption tests

62. A cross-linked acrylate fiber is known to have high moisture absorption performance, and is used in a clothing field and an industrial material field.

63. This proposal was countered by some as not necessary because the shape of the head restraint is governed by the displacement test, energy absorption test, and other requirements

64. This proposal was countered by some as not necessary because the shape of the head restraint is governed by the displacement test, energy absorption test, and other requirements.

65. A neutron moisture meter using a scintillation detector for slow neutrons was previously calibrated in materials carefully selected to avoid inaccuracies resulting from neutron absorption.

66. An electromagnet generates a magnetic field at the site of an atomized test sample in an atomic absorption spectrometer.

67. Sampling frequency of the receptor fluid should allow the absorption profile of the test substance to be presented graphically

68. Moisture content

69. A sample meter includes a first end for absorption of a test sample, and a storage section that receives and stores at least a component of the test sample.

70. Supplemental approaches beyond the in vivo experiments described in this Test Method may provide useful information on the absorption, distribution, metabolism or elimination of a test chemical in certain species.

71. □ Practice moisture control.

72. Cellulose Acetate Butyrate (CAB), commonly known as Butyrate, is resistant to ultraviolet rays, has a lower moisture absorption than acetate and has an extremely high impact strength

73. FINAL MOISTURE CONTENT

74. Under this test, several samples of soil of very different moisture contents are air-dried, and a certain amount of water is added to them.

75. This substrate enables pits or grooves to be accurately transferred, is less likely to cause warpage derived from absorption of moisture, and has a high-density recording capacity.

76. Moisture content: Max 8,0 %

77. An experimental investigation is reported of drying and conditioning concrete at 50°C to obtain a uniform moisture distribution, prior to testing for air permeability and water absorption rate.

78. The calcium-pectin coating functions to significantly impede the absorption and adsorption of frying oil, increases the moisture content, the crispness and heat lamp stability of the food composition.

79. Bamboo charcoal shoe pad is one kind of health care product, long-term using charcoal shoe pad will help user on antivirus, odor elimination, moisture absorption and dermatophytosis prevention.

80. Moisture-setting polyurethane adhesive