1. Unit: Buffers, titrations, and solubility equilibria

2. -Physical appearance, complete medium solubility, DMSO solubility, molecular weight, and additional relevant physicochemical properties, to the extent available;

3. Ammonium Bisulfate addition to the above solutions lowered (NHjpSO, solubility, decreased pH, increased density, and lowered S02 solubility

4. They differ in solubility and chemical reactivity.

5. Solubility of Acetylated Lignin in Organic Solvents

6. Anastrozole, USP has moderate aqueous solubility (0.5 mg/mL at 25°C); solubility is independent of pH in the physiological range

7. Solubility: soluble in alcohol, chlorinated solvent, aromatic solvent.

8. -physical appearance, water solubility, and additional relevant physicochemical properties;

9. Its solubility and supersaturation were determined under various conditions.

10. The solubility of a gas decreases with increasing temperature.

11. Increasing pressure also increases the solubility of calcium carbonate.

12. Pervaporation flux depends upon the value of equilibrium solubility.

13. According to the Biopharmaceutical Classification System (BCS) drug substances are classified to four classes upon their solubility and permeability: Class I - high permeability, high solubility

14. The correlation of the decreased apparent energies of activation with the specific solubility parameter of the solvents used in these investigations yields the solubility parameter of the PET-fibre: total solubility parameter:δT,PET = 9,9 (cal/ccm)1/2 hydrogen solubility parameter:δh,PET = 5,5 (cal/ccm)1/2 polar solubility parameter:δp,PET = 3 (Cal/ccm)1/2 non-polar solubility parameter:δnp,PET = 7,7 (cal/ccm)1/2. The activation energy of the short range diffusion of the chain segments in the amorphous regions in a swollen PET-fibre has been evaluated to 17 (kcal/mol).

15. At elevated temperature its solubility in water is much higher.

16. Besides acidity, solubility is an important factor governing pharmacological activity.

17. -Physical appearance, water solubility, and additional relevant physico-chemical properties;

18. — at least 2 % P2O5 soluble in mineral acids only [solubility (4)];

19. All high melting point phases vanish. The solid solubility increases greatly.

20. The Binodal or coexistence curve describes the limits of solid solubility

21. The mechanism by which MBP increases solubility is not well understood.

22. Just like BaSO4, BaMnO4 exhibits low solubility in virtually all solvents.

23. Axoplasm chemical composition in Myxicola and solubility properties of its structural proteins.

24. Barytes Powder exhibits low abrasion property, low solubility, and low oil absorption

25. The solubility of Acetylated lignin in organic solvents is demonstrated in Fig

26. The Aggressiveness of various sulfate salts towards concrete is partly related to solubility.

27. The temperature at which an inverse solubility occurs is often termed cloud point.

28. Acetanilide has a much higher solubility in hot water than in cold water.

29. Anhydrite solubility is independent of pH and generally forms close to the wellhead.

30. The solubility of Acetanilide in hot water (5.5 g/100 ml at 100 oC) is not very great, and its solubility in cold water (0.53 g/ 100 ml at 0 oC) is significant

31. The precipitate represents AgAdHNO3, solubility product of which amounts to 1.4·10−6.

32. The cell wall swelling during NH3 treatment improves the alkali solubility of polyoses.

33. At doses above # mg, the absorption was saturated probably due to poor solubility

34. Their solubility in water enables them to be transported readily in body fluids.

35. Dosage forms for low solubility and/or low dissolution rate free acid pharmaceutical agents

36. The presence of sickle haemoglobin can also be demonstrated with the "sickle solubility test".

37. It is a white solid with low solubility in water (Ksp = 5.61×10−12).

38. It provides the lubricant with good Antirust and demulsifying performance, and oil solubility as well

39. Solubility in formic acid (only for soft rock phosphate): minimum level 55 % of total P.

40. Amine compounds can hydrogen bond, which affords them solubility in water and elevated boiling points

41. The fluid must be examined relatively soon after aspiration, as temperature and pH affect solubility.

42. The solubility profiles of oxalic and malonic acid in various dioxane-water mixtures are reported.

43. The gums could increase the water solubility and decrease the volume expansion of starch extrudates.

44. The zone of inhibition will also be affected by the solubility of the Bactericide (i.e

45. The temperature-dependent solubility product Ksp (AgCl) affects the blank correction for unbiased SO4 estimates.

46. A reference standard cloth was compared with samples that had undergone an alkali solubility test.

47. solubility in formic acid (only for soft rock phosphate): minimum level 35 % of total P.

48. Alcohols are less volatile, have higher melting points and greater water solubility than the corresponding alkanes

49. — when the water-soluble P2O5 does not amount to 2 %, solubility (2) only shall be declared,

50. Water miscible hydroxyethyl cellulose ( HEC ) was modified to increase its fat - solubility by reacting with hexamethyldisilazan.

51. We determined and analyzed the denaturalization temperature and the ability of water-retainment and protein solubility.

52. For example, the solubility of Acetanilide in ethanol at 0 ºC is about 18g/100mL

53. The solubility of C in Austenite drops steadily from ~ 1·7% at 1130 °C to ~ …

54. solubility in formic acid (only for soft rock phosphate): minimum level 55 % of total phosphorus (P);

55. Finally, the solubility of methyl chloride in solvent naphtha was mensurated to accord to industrial application.

56. The solubility and thermal properties of copolymers and contact angles of block copolymeric films were measured.

57. Because solubility depends on temperature, a solution that is Concentrated at one temperature may not be Concentrated

58. Abietic acid solutions are in their purest form and have a water solubility of up to 100%

59. Depending on the membrane and the solute, permeability may depend on solute size, solubility, properties, or chemistry.

60. 15 They characteristic of low melting point, low vapor pressure, adjustable acidity, strong solubility and high viscosity.

61. 9 Finally, the solubility of methyl chloride in solvent naphtha was mensurated to accord to industrial application.

62. Aluminic acid solutions are in their purest form and have a water solubility of up to 100%

63. The solubility, spectral characteristics, andpK values are reported, as well as the absorptivity of metal chelates formed.

64. Compared to Pd, Au has higher activity coefficients in Fe-metal and lower solubility in silicate melts.

65. Values of the solubility parameter for simple liquids can be readily calculated from the enthalpy of vaporization.

66. Since the possibility of the release of arsenic compounds into the water due to the dissolution of formed Arsenates depends on its solubility under appropriate conditions, it is necessary to have information about the dependence of Arsenates solubility on pH.

67. The solubility and stability of calcium Arsenates at 25 ∘C was determined by both precipitation and dissolution experiments

68. The solubility and stability of calcium Arsenates at 25 ∘C was determined by both precipitation and dissolution experiments

69. The quantitative computation of balanced solid solubility of multiplex second-phase is a difficult problem in this area.

70. The remarkably high solubility of dimetalated silylphosphanes and Arsanes, respectively, is due to the lipophilic surface of the

71. The present results show that dietary calcium has a site specific effect on the solubility of bile acids.

72. 20 Values of the solubility parameter for simple liquids can be readily calculated from the enthalpy of vaporization.

73. The solubility of cadmium in water is influenced to a large degree by the acidity of the medium.

74. Biotransformation increases water solubility of the drug, making it easier to excrete, and it (most frequently) inactivates the drug

75. Lead solubility and lead release are dependent on pH, alkalinity and corrosion inhibitor (orthophosphate) concentration (Schock et al., 2005b).

76. For condensed phases (solids and liquids), the pressure dependence of solubility is typically weak and usually neglected in practice.

77. The solubility, dielectric constant, and dissipation factor of the polymer were improved alter acetyl substitution of poly(p-xylylene).

78. 23 The present results show that dietary calcium has a site specific effect on the solubility of bile acids.

79. Similar to calcite, Anhydrite has retrograde solubility and also forms in production wells but is less common than calcite

80. Cystine is relatively insoluble in aqueous solutions such as urine with an upper limit of solubility is 243 mg/L