1. A user - defined pore pressure distribution cannot be used to interpolate pore pressures in other clusters.

2. Lai Ping Road, rainfall patterns, pore-water pressure distributions, suction, unsaturated slope.

3. gas-tightness test, carried out with air or an inert gas at a pressure # bar above atmospheric pressure

4. Waste gas removal system using low-pressure and atmospheric pressure plasma

5. Key words: consolidation, pore-water pressure, average degree of consolidation, total stress, clay, soil.

6. Method and apparatus for drilling a borehole into a subsea abnormal pore pressure environment

7. Low pressure liquefied gas: a gas with a critical temperature above # °C

8. Bulk, liquified gas (at abnormal temperature/pressure

9. Bulk, liquefied gas (at abnormal temperature/pressure)

10. Relays, electric sensors, gas, light, acoustic, pressure

11. low pressure liquefied gas: a gas with a critical temperature above + 65 °C.

12. ii) Low pressure liquefied gas: a gas with a critical temperature above # °C

13. Low pressure liquefied gas: a gas with a critical temperature above +65 °C;

14. Low pressure liquefied gas - a gas with a critical temperature above +65 °C;

15. Low pressure liquefied gas: a gas with a critical temperature above +65°C.

16. Key words: matric suction, mini suction probe, triaxial, unsaturated soils, mid-height pore-water pressure measurement.

17. Low pressure liquefied gas: a gas with a critical temperature above +65 °C.

18. Various valves, pressure regulators, pressure gages, needle geometries, gas selections are also presented.

19. Key words : constitutive equations, creep, finite element, stress integration algorithms, effective stress approach, pore-water pressure.

20. High pressure Low Density Polyethylene Gas compressor lubricant.

21. Finally through analyzing the of fracture pressure, caving pressure and pore pressure, three calculation models are building and explanation cut plane of land facies of typical well is formation.

22. Now, the Ideal Gas Law implies that as the pressure decreases, gas volume increases.

23. Under (4), replace "Gas cylinders and gas receptacles" with "Cylinders, tubes and pressure drums ".

24. Gas engine system with detection function of abnormality occurrence of gas pressure detection mechanism

25. Passing seismic waves may trigger a local pore-pressure increase according to the mechanism of advective overpressure.

26. Key words : oil sand, stress, strain, void ratio, pore pressure, temperature, mode of granular interaction, critical state.

27. The gas is stored under pressure in the tank.

28. Substrate processing apparatus using high-pressure processor and gas recycling method of high-pressure processor

29. Scuba divers breathe compressed air or other gas mixtures at a pressure matching the water pressure.

30. Separation column and pressure swing adsorption process for gas purification

31. Admissible pressure loss in the end-user gas installation [mbar]

32. Thruster components and fittings (high-pressure gas balloons, tubing, etc.)

33. Gas-permeable porous body, its production and pressure casting mold

34. Transducers for blood pressure, blood gas and heart activity detection

35. - control of pressure of inert gas and oxygen content thereof,

36. Gas generator rocket can pressurize a high - pressure feed system.

37. Pressure swing adsorption method and system for separating gas components

38. admissible pressure loss in the end-user gas installation [mbar]

39. Finally, analyses considering pore-water pressure dissipation during the actual elapsed time for each construction phase were carried out.

40. At standard temperature and pressure, ethane is a colorless, odorless gas.

41. The gas pressure in submarine section is 25 MPa (250 atm).

42. Admissible pressure loss in the end-user gas installation [mbar] (3)

43. Low pressure liquefied gas- gases with a critical temperature above # °C

44. Z= gas compressibility factor in the accumulating condition (24 bar pressure).

45. Admissible pressure loss in the end-user gas installation in mbar:

46. Pressure of the gas to be measured and of scavenging air

47. The hydrogen gas separation system or the oxygen gas delivery system may include a pressure swing adsorption module.

48. Stovetop pressure Cookers use the heat from a gas electric burner to build pressure inside the cooking chamber

49. Gas flow is a function of inlet pressure and temperature, pressure drop between the SSV inlet and throat.

50. Product Description The Accu-Pressure™ Type Y692 Gas Blanketing Regulator (Figure 1) is a pressure reducing direct-

51. The lubricant is under the gas pressure prevailing in the cylinder with a pressure transmitting element being interposed.

52. Considering the actual characteristics of gas-fired boiler, a boiler pressure control strategy based on feedforward signal of blast furnace gas main pipe pressure is presented in the paper.

53. High pressure liquefied gas: a gas with a critical temperature above # °C and equal to or below # °C; and

54. Types of Aerated concrete: Based on the method of pore-formation it is classified into two types as follows: Gas Concrete: Gas concrete is a mixture of water and cement, very good aggregate with the final addition of a pore-forming chemical that produces air-voids within the …

55. This tools supports Anneals under several gas flows and below atmosphere pressure.

56. underground storage facilities connected to the above mentioned high-pressure gas pipelines

57. Barotrauma is an injury caused by a difference in pressure between a gas inside, in contact with, or outside the body and the pressure of the surrounding gas or fluid

58. - underground storage facilities connected to the above-mentioned high-pressure gas pipelines,

59. Low pressure liquefied gas - gases with a critical temperature above +65 °C;

60. The method is the cone penetration test (CPT), which measures the penetration resistance and excess pore water pressure of the soils.

61. Thus, above the critical temperature a gas cannot be liquefied by pressure.

62. underground storage facilities connected to the above-mentioned high-pressure gas pipelines;

63. Methods and apparatuses for gas separation by pressure swing adsorption with partial gas product feed to fuel cell power source

64. Meters must incorporate both upstream and downstream in the gas circuit a static pressure tapping for measuring the pressure absorption

65. (b) underground storage facilities connected to the above mentioned high-pressure gas pipelines;

66. Gas density is adjusted only if chamber pressure is maintained within acceptable levels.

67. A gas shock absorber has a pressure tube which defines a working chamber.

68. Device for preventing slag outflow and high pressure gas injection lance used therein

69. Blow moulds, namely blow nozzles for generating high-pressure air or gas streams

70. Differential pressure means for a gas meter arrangement, comprising an improved flow geometry

71. (b) underground storage facilities connected to the above-mentioned high-pressure gas pipelines;

72. (b) underground storage facilities connected to the above-mentioned high-pressure gas pipelines,

73. Low-pressure drop structure of particle adsorbent bed for adsorption gas separation process

74. Servocontrol of gas pumping and/or supply rate stabilizes pressure, absorbance, or both.

75. High pressure liquefied gas: a gas with a critical temperature above -50 °C and equal to or below +65 °C; and

76. Reservoir for fluids under high pressure, in particular compressed air or another gas

77. His law states that gas volume varies inversely with pressure at constant temperature.

78. Alternatively, the pressure readings may be converted to volumes (at 35 °C, atmospheric pressure) of gas produced using a conversion graph.

79. A gas compressor is used to heat the gas CO2 refrigerant to around 100°C under pressure of 10MPa via adiabatic compression.

80. Extraction of natural gas (or oil) leads to decrease in pressure in the reservoir.