Nghĩa của từ hypoid pinion bằng Tiếng Việt
@Chuyên ngành kỹ thuật
@Lĩnh vực: cơ khí & công trình
-bánh răng xoắn (hypốit)
Đặt câu có từ "hypoid pinion"
1. Pinion angle level gauges
2. Rack and pinion sieve adjustment mechanism
3. End play in drive pinion bearings.
4. Install pinion front bearing, if necessary.
5. Usually, we adopt pinion drive for large mills.
6. Rotate the pinion yoke three or four times.
7. Bearing assembly, mounting of a bevel pinion shaft
8. Refer to Drive Pinion Bearing Pre - Load Adjustment.
9. Rack and pinion mechanism, accessor, and magnetic tape device
10. Worn teeth on ring gear or drive pinion gear.
11. Why don't you try tightening the pinion nut first?
12. Check ring gear and pinion gear teeth contact pattern.
13. The tooth surface form has the determinative effect on the performances of a hypoid gear drive.
14. The disclosed pinion shaft support structure allows attachment of pinion shafts in a phase-aligned state by one simple process not requiring special equipment or a staking step.
15. Bearing for a drive pinion shaft, especially an all-wheel front-axle transmission
16. Rack and pinion steering gear with automatic adjustment of the thrust element
17. A high pressure oil which suits the lubrication of hypoid gears and cogs submitted to extreme loads in severe conditions.
18. Cinq is raising funds for Cinq Shift:R for Pinion on Kickstarter! The world's first drop-bar road shifters (Shift:R Road) and flat-bar trigger shifters (Shift:R Tour) for Pinion gearbox equipped bikes
19. Rack mounting auxiliary adjusting apparatus used for rack and pinion climbing vertical ship lift
20. The mounting plate comprises an interface adapted to be Circumjacently mounted about the differential drive pinion gear, and a torque arm bracket integral with the interface and spaced apart from the differential drive pinion gear
21. The wings of the ostrich flap joyously: Are they the pinion and plumage of lovingkindness?
22. The set consists of an 18T hardened steel pinion and an extremely strong 56 plastic spur gear.
23. Thus the actuation of the control valves is independent of the helix angle of the pinion teeth.
24. In case of single portal axles (SP): Angle between pinion axle and crown wheel axle within ± 3,5°
25. The clutch disk allows the pinion gear to move with the rack when the mirror is manually adjusted.